I've been trying to turn on my computer when I'm away from the house using both mobile data and another WiFi connection. When I'm on the same network the wake up command works but if I'm using mobile data I'll get the message "Wake up command failed" and when I'm on another network it says "wake up command sent" but nothing happens. I have the necessary port forwarded (UDP 9) and through the Pulseway android app port monitor I can see it works. Any help would be greatly appreciated.
By Andy Raybould
Could someone assist in helping me to set up an alert when a network connection is dropped.
This is happening at one of my client sites after changing to a new ISP. The ISP says the router/switch is fine but connections are dropping.
I would like to be able to log when a connection drops (ideally knowing if the internet connection has dropped or just the internal network connection)
I'm not sure a simple ping notification is good enouh in Pulseway to do this as I need to know if the connection has dropped for a few mseconds as well as larger outages.
I guess the Event Viewer holds the answers but would appreciate it if anyone has done this before if they could share their thoughts.
Thank you, Andy
I am attempting to install pulseway on my raspberry pi 3b+, and have downloaded and installed the correct file from the pulseway website, and made sure that my openssl libraries are up to date and correctly setup. I followed through with the given installation instructions and repeatedly the pulseway service is unable to be started. When executing the command sudo systemctl start pulseway, the command works and presents no errors. Upon checking the app or the list of all services, however, pulseway is not shown as a service and there is no devices connected to the app. See the attached images for the output of sudo systemctl status pulseway
I have used the rest api Publish and Notify to make a system in Pulseway.
When I run the api the system will be updated and there will be notifications of the devices I monitor. (if their are up or down)
But if I run the script I get alle the notifications that I don't want because the state isn't change of the devices.
Is there a php script that makes the Pulseway Notifiy api remember the state of the last send notification so there will only be send a notification if the state is change since the last send notification?