By Andy Raybould
Could someone assist in helping me to set up an alert when a network connection is dropped.
This is happening at one of my client sites after changing to a new ISP. The ISP says the router/switch is fine but connections are dropping.
I would like to be able to log when a connection drops (ideally knowing if the internet connection has dropped or just the internal network connection)
I'm not sure a simple ping notification is good enouh in Pulseway to do this as I need to know if the connection has dropped for a few mseconds as well as larger outages.
I guess the Event Viewer holds the answers but would appreciate it if anyone has done this before if they could share their thoughts.
Thank you, Andy
Has anyone got some advice on monitoring McAfee please? We need a way to monitor to the AutoUpdate so it alerts us if this has not run.
Previously we have a script that checks the registry of each server then sends an email with the information, however we would like to replace this with a Pulseway alert if out of date.
I have searched the forum but the last post is from 2012 so i was hoping there is a solution to this. Also looked from registry/WMI queries but that seems to be for reporting rather than monitoring.
I added two switches to one of my Pulseway clients to monitor over SNMP.
I added the agents in server modules > SNMP and then added the triggers in Notifications. I pulled a power cord on one of the switches and the alert tripped right away sending notifications to my phone and dashboard. I pulled a PSU cord on the other switch and no alerts. Looking at the values (3 is working correctly) I see the PSU value has changed to 5. Obviously out of tolerance but no alerts. I then recreated the variables for the agents seeing if something went wrong. Now the switch that didn't alert the first time alerts but the one that was working doesn't alert.
Can someone shed some light on this? I included a screenshot to show that the SNMP portion is configured correctly and showing the values it should for alerts to be triggered.
I am attempting to install pulseway on my raspberry pi 3b+, and have downloaded and installed the correct file from the pulseway website, and made sure that my openssl libraries are up to date and correctly setup. I followed through with the given installation instructions and repeatedly the pulseway service is unable to be started. When executing the command sudo systemctl start pulseway, the command works and presents no errors. Upon checking the app or the list of all services, however, pulseway is not shown as a service and there is no devices connected to the app. See the attached images for the output of sudo systemctl status pulseway