Share your SNMP settings. :-)

[affer]

This is just a thread for sharing SNMP OID

 

UPS (APC) 

Battery time remaining - .1.3.6.1.4.1.318.1.1.1.2.2.3.0

Current input - .1.3.6.1.4.1.318.1.1.1.3.2.1.0

load in percent - .1.3.6.1.4.1.318.1.1.1.4.2.3.0

output voltage - .1.3.6.1.4.1.318.1.1.1.4.2.1.0

time since switch to battery - .1.3.6.1.4.1.318.1.1.1.2.1.2.0

 

all except the last one is integers, the last one is the one i  made a notification on, when it is not equal to standard i get an critical alarm (power loss)

 

//Affer

Denmark

 

Please share 

[nullmem]

I have environmental notifications for all my Cisco gear:

 

Temp

.1.3.6.1.4.1.9.9.13.1.3.1.3.1

 

Fan 1 Status:

.1.3.6.1.4.1.9.9.13.1.4.1.3.1

Fan 2 Status:

.1.3.6.1.4.1.9.9.13.1.4.1.3.2

Fan 3 Status:

.1.3.6.1.4.1.9.9.13.1.4.1.3.3

 

Status integer of 1 = OK

Status integer of 2 = Warning

Status integer of 3 = Critical

Status integer of 4 = Shutdown

Status integer of 5 = notPresent

Status integer of 5 = notFunctioning

[affer]

http://www.opennms.org/wiki/HP_Insight_Manager

 

This site is usefull, i used it for my HP 4730 SAN

 

for the single disk i started from:

 

.1.3.6.1.4.1.232.3.2.5.1.1.6.0.8

cpqDaPhyDrvStatus Port 1I Box 1 Bay 1

to .1.3.6.1.4.1.232.3.2.5.1.1.6.0.32

 

(all 25 disks)

[Cor van Vaneveld]

Someone SNMP Settings for QNAP NAS?

 

[Paul]

Hi Cor,

Have you tried these OIDs: http://www.oidview.com/mibs/24681/NAS-MIB.html?

-Paul