Hi

I am currently testing Pulseway Remote Desktop on my own network and have RD, Manager and Dashboard

installed on both Windows 7 and Windows 10 PC's.

Both systems can see each other in Manager etc. but when I launch an RD session I get the error,

"The agent failed to start the session" any ideas.

Thanks in advance,

D.

Hi,

Are you using a proxy to connect to the internet? If so, what authentication protocol does it use?

Chris

Hi Chris

No i'm not using a proxy, direct access. (Testing on my home network)

Best Regards,

Daragh

Hi Daragh,

Please send an email to support [at] pulseway.com, I'll escalate your request to L2 technical support.

Chris

Thanks Guys sorted..

What was the fix for this? Having a similar issue. I tried leaving the other boxes unchecked and then set it to default connect if the user did not respond but still no luck.

Enable the diagnostics mode in the Pulseway Manager on the remote machine. Then try again to connect to the remote machine. After you have done this disable the diagnostic mode. In the Pulseway directory, where the Pulseway agent is installed, you will find two files (trace.log and rd_agent.log). Please send these files to Pulseway support including a link to this thread.

Thanks